Neve 80 Series Male Card Edge Connector

What it is

• A bare PCB: the “male” edge interface that plugs into the standard female backplane or rack slot for 80-series Neve modules.

• It carries the pad layout and contact fingers typical of the 80-series format.

• The board supports reliable electrical connection from your custom module (or adapter) into the 80-series compatible rack system.

Key considerations

• You’ll still need to design or adapt your own module board so its rear edge aligns with the connector’s finger pattern and mating slot.

• Match power rails, signal pins, keying, and mechanical alignment carefully—80-series racks follow a convention, but variations exist.

• This connector board does not provide the module electronics, housing, or rack-side socket—just the edge interface.

• Pay attention to wear, insertion cycles, and contact resilience, especially in a rack environment.

Why use it?

• If you’re building or modifying a module to fit into a Neve 80-series rack and need the correct edge interface without pulling an existing board.

• If you have a custom or legacy board and want to interface it into the 80-series ecosystem.

• Useful in DIY, repair or retrofit contexts where the edge connection is the critical interface.